Jeep Cherokee / Wrangler XJ transfer case linkage kit
**Special Note: These items ship directly from Azzy Design Works, K Suspension is not responsible for shipment times and/or issues, please contact Azzy Design Works if any issues arise.**
New v7 XJ features:
Ability to adjust 30 degrees
Stainless steel upper and lower link plates
Dual stabilization arm on upper links
Tired of your hard to adjust rube goldberg contraption that never seems to let you put your Jeep in 4L? Does you Jeep pop out of 4H when you flex too much? Our kit is bolt on, and simple yet effective. Junk the old "Z" linkage or bell crank, remove the lever from your transfer case, and install. Adjust, test, and go hit the trail. with our new custom built hardware, adjusting is easier than ever with just a pair of pliers, guesswork is dropped by 85%. This is everything to replace the crummy factory operation. NO DRILLING OR WELDING REQUIRED!
Tested to fit Cherokee XJ AW4, AX15, & NP231 and NP242 combos. Limited reports of use in ZJ Grand Cherokees. Contact us first.
Exact hardware subject to change as we strive to improve while keeping the cost low. Standard kits are powder coated, stainless kits use all stainless hardware except for the standard rod ends. We can supply stainless rod ends at an extra $60 per kit, email for details.
All hardware sourced from US suppliers and manufacturers. Designed, tested, and assembled in PA.
this hardware is for use by experienced mechanics only. We take no responsibility for the modification of your vehicle by your hands or those of a 3rd party. Please don't do anything stupid and get hurt with our products, we like our customers!
There will be a 15% restocking fee applied to opened or installed linkage kits that are returned.